如何选择丁基胶涂布机的材料选择CED-282

一、玻璃的选用

A, the selection of the glass

1、制造丁基胶涂布机的原片玻璃可以是无色浮法玻璃、镀膜玻璃、钢化玻璃、夹层玻璃等。应避免使用普通平板玻璃,普通平板玻璃的透明度及强度均达不到要求。上述玻璃原片必须符合相应标准要求,经检验合格后才能使用。

1, the asreceived manufacturing butyl rubber coating machine can be clear float glass, coated glass, toughened glass, sandwich glass, etc. Avoid using common plate glass, transparency of the ordinary plate glass and strength can not meet the requirements. The glass glass must comply with the relevant standards, the inspection before use.

2、不同厂家不同批次的玻璃在切割前应首先检查有无色差,将色差较大的玻璃分别用于不同的工程或不同的建筑立面中。

2, different manufacturers in different batches of glass cutting before should first check the presence of chromatic aberration, the color difference bigger glass respectively used in different engineering or building facade.

3、玻璃切割尺寸应按图纸要求严格执行,同时操作人员应注意玻璃表面,不得有划伤、气泡等明显缺陷。

3, glass cutting size should be implemented strictly according to the requirements of drawings, at the same time, the operator should pay attention to the glass surface, can not have obvious defects such as scratch, bubble.

二、铝条、插角的选用

Second, the selection of aluminum bar, Angle

1、铝条的厚度应在0.30mm~0.35mm之间,厚度应均匀一致,透气孔分布均匀。铝条须经阳极氧化处理或去污处理,一定要选用质量好、档次高的产品,提高铝条利用率。

1, the thickness of the aluminum bar should be between 0.30 mm to 0.35 mm, thickness should be uniform, air holes evenly distributed. Aluminum strip must be approved by anodic oxidation treatment or decontamination treatment, must choose good quality, high grade of products, improve the utilization rate of aluminum strip.

2、插角尺寸要选好,表面要擦干净。

BACK PAGE